Content on this page supplied from the web site of Jim Lux
At first glance, the readily available wirewound power resistor appears to be a good solution to inexpensive high voltage resistor requirements. The breakdown voltage is typically several kilovolts per inch of length, so a 100 watt resistor 6 inches long will probably work at 20 kV, particularly for an application where the substantial inductance isn't a problem. However, in systems where there is a lot of stored energy, the failure mode for these resistors can cause catastrophic damage to other components.
A wirewound resistor is made by winding a very fine resistance element (e.g. Nichrome) on a ceramic form. If a small open develops (the typical failure mode, either due to a physical impact deforming or severing the wire, or due to excessive power disspation) an arc will form at the gap, melting the wire back, making the arc bigger. This is a continuing process that can be quite spectacular.
Copyright 1997, Jim Lux/ resww.htm / Back to Resistor page / Back to High Voltage Main Page / Back to home page / Mail to Jim (jimlux@earthlink.net)
